Vox Valvenergy Copperhead Drive

• Equipped with Nutube, providing vacuum tube sound and response
• Buffered bypass reduces noise when the effect is turned off
• Connection mode can be switched according to your use
• Channel switch function allows operation similar to a multi-channel amp when multiple VALVENERGY series units are connected
• OLED display provides a visual indication of the sound
• GAIN knob: Sets the amount of distortion.
• VOLUME knob: Sets the final volume.
• TREBLE knob: Adjusts the high-frequency range. Turning the knob toward the left produces a softer tone, and turning it toward the right provides a bright tone.
• MIDDLE knob: Adjusts the mid-frequency range. Turning the knob toward the right provides a rich mid-range.
• BASS knob: Adjusts the low-frequency range. Turning the knob toward the left produces a thinner and lighter tone, and turning it toward the right provides a warm and heavy tone.
• BRIGHT knob: This is placed before the distortion stage, providing a different character of distortion at each position of the switch.

Analog circuit design with ample headroom
The VALVENERGY series is made of all analog circuits with the 9V power supply voltage boosted to 15V internally. This allows for greater volume and headroom, and delivers an even more dynamic sound. It's a circuit design that fully utilizes the potential of the VALVENERGY series.

Three connection modes that you can switch according to your situation
You can switch modes as appropriate for the way in which you're using the pedal.

STANDARD: The pedal outputs an instrument-level signal. Connect to the input of your guitar amp in the same way as when using a conventional pedal.

PREAMP: The pedal outputs a line-level signal. Connect to the return jack of your amp or to the input of your power amp to then use with a guitar cabinet.

CAB-SIM: The pedal outputs a line-level signal with an analog cabinet simulator. Connect to your mixer or DAW for direct guitar tones.

Equipped with a channel switching function
You can chain two pedals together with a standard 1/8” stereo cable through the CH-SW (channel switch) jack of each pedal. This allows you to turn one pedal on while bypassing the other, using the system as if you were switching between channels of a guitar amp.

By using a split Y-configuration 1/8” stereo cable you can link three pedals.

OLED display provides visual confirmation of the sound
These pedals are equipped with a high-contrast OLED display showing an oscilloscope, a visual indication of how the waveform is affected by the knob settings.